hoodie drawstring stopper manufacturers take you to understand the common problems and applications of I-shaped buckles

The hoodie drawstring stopper manufacturer tells you that buttons appeared very early in the history of clothing development in my country. Today, let's take a look at the common problems and applications of I-shaped buckles.

1. Hit the jeans and pull it apart with a little force, the nails and buttons are not tight
If it is a rubber core I-shaped buckle, it is related to the rubber core of the I-shaped buckle. If the rubber core is made of almost plastic, it will not be able to withstand the pressure of the nails and will be squeezed open. So if we pull hard, it will fall off. And with good plastic - new material, this will not happen. At the same time, it is also related to the shape of the nail. There are sharp nails and threaded nails. Generally, threaded nails are used.
2. Put the nail into the button, and directly penetrate the surface of the I-shaped button
It can be found by simple analysis, but the panel of the I-shaped buckle is too thin. The manufacturer of the hoodie drawstring stopper tells you that you can't bear the force of the nails at all, and the button surface can be pierced all at once. This kind of situation is relatively rare, such as alloy, copper, iron I-shaped buttons, and it is rare to make ordinary ones, unless they are deliberately hit hard, the surface will be pierced.
3. The I-shaped button is fastened to the jeans, and the surface loses color
The hoodie drawstring stopper manufacturer tells you that this problem is actually relatively simple. The surface of the I-shaped buckle is discolored, which is generally related to electroplating and painting. The electroplating is not good, and the color of products without oil sealing generally does not last long. After oxidation in the air , the color will fade, and sometimes it will fall off during friction. In the case of spray painting, the paint falls off, which is related to the composition of the paint sprayed on the product. Generally, good paint will not fall off, unless it is a very poor paint.
4. I-shaped buckle is rough
The button has this problem, which is related to the surface treatment process of the factory, the polishing is not in place, and the mold of the product is not well opened. Doing these things can completely avoid it.
The manufacturer of hoodie drawstring stopper tells you that there are also I-shaped buckles according to different customer requirements, such as glue, spray painting, hanging plating, etc. The problems that occur are also determined according to the specific situation.